Yard Machines MTD1400K Operator's Manual download pdf (Page 8)

RULES FOR SAFE OPERATION ASSEMBLY INSTRUCTIONS

KNOW YOUR UNIT

TOP HOPPER

SAFETY SCREWS

WHEEL

TOP HOPPER

KNOB

WHEEL COVERS

CONNECTING WHEEL ASSEMBLY

TE:

Locate small bag of hardw

are containing two Allen

hex screws, two large flat washers, two small flat washers

and two split pins.

1. Place one wheel on the axle followed by a large flat

washer. Secure by inserting a split pin through the hole

in the end of the axle, bend the ends over using pliers.

(Fig. 3)

2. Press wheel cover on wheel.

3. Position the axle assembly on the inside of the support

tube as shown in Fig. 4, aligning the hole in the axle

with the hole in the support. Place a lockwasher and

small flat washer on the Allen hex screw and guide

them up through the hole in support tube and into the

hole in the axle.The flat washer should be next to the

axle.

4. Assemble the other tube support to the other end of the

axle in the same manner.

5. Attach the second wheel to the axle using the same

method as described in step 1.

MOTOR ASSEMBLY & WHEELS

NOTE: Locate small bag of hardware containing four flat

washers, four lockwashers and four hex nuts.

1. Remove feeder tube from motor assembly by loosening

3 Spring Loaded caging knobs. (Fig. 5)

2. Lay motor assembly down on flat surface with cord and

switch facing up.

3. Aliqn support tubes of wheels to motor assembly.

4. Secure with flat washers, lockwashers and hex nuts as

shown in Fig. 5 & Fig. 6.

5. Reassemble the feed tube with the chute over the

flange, replace and tighten the three caging knobs.

HOPPER ASSEMBLY

NOTE: Locate small bag of hardware containing five one

y security screws and washers.

1.Place the hopper on top of the feed tube, align the holes.

Secure with the safety screws and washers. (Fig. 7)

Fig. 3

DISCHARGE CHUTE

LEG(R)

LEG(L)

WHEEL

OVERLOAD

PROTECTION

SWITCH

ON/OFF SWITCH

Fig. 4

Axle

Motor

Assembly

Feeder Tube

Axle

Flat Washer and Split Pin

Tube Insert

Support Tube

Axle

Allen hex screw,

small flat washer

and lockwasher

Feed Tube

Chute

Caging Knobs

Screws

Blade

Set Screws

Fig. 5

Fig. 6

Flange

Fig. 7

Use caution when

tightening set screws

to avoid contact with sharp cutting blades.

WARNING:

u u u u u

For Parts Call 606-678-9623 or 606-561-4983

www.mymowerparts.com

For Parts Call 606-678-9623 or 606-561-4983

www.mymowerparts.com

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 45 46

Comments to this Manuals

No comments

Yard Machines MTD1400K Operator's Manual Page 8

Comments to this Manuals

Related products and manuals for Power tools Yard Machines MTD1400K